Memtest Results Help
Discussion
I've ran Memtest in order to get to the bottom of 'the dreaded blue screen of death' (tm).
The results showed that the memory had about 4000 errors, doh!
Im currently running 192 Meg of RAM, in what I'd guess to be 3 * 64 meg chips.
The errors were all from 156M upwards, so presumably, only in one chip. (I dont know the difference between dimms and simms etc).
How do i tell which bank the error is in, without taking each one out and running individual tests, or is this the only way?
IS it better to replace just the one bank, or swap them all as a matter of course - I'd probably pit about 500 meg in if i did this.
What do you think?
MrF
The results showed that the memory had about 4000 errors, doh!
Im currently running 192 Meg of RAM, in what I'd guess to be 3 * 64 meg chips.
The errors were all from 156M upwards, so presumably, only in one chip. (I dont know the difference between dimms and simms etc).
How do i tell which bank the error is in, without taking each one out and running individual tests, or is this the only way?
IS it better to replace just the one bank, or swap them all as a matter of course - I'd probably pit about 500 meg in if i did this.
What do you think?
MrF
The simplest method of isolating failed RAM modules after running memtest is unfortunately,like you said, to remove the modules in turn and re-run the test. You dont have to replace them all, just the faulty one. Make sure any new ram is compatible though.
>> Edited by jam1et on Wednesday 28th April 14:26
>> Edited by jam1et on Wednesday 28th April 14:26
Plotloss said:
Pull bank 3 (or 2 if its 0 indexed) first though.
I'd agree - memory is usually (always?) counted from the 1st bank upwards, so errors in the top 3rd should be contained to the module in the 3rd bank.
[Should note that this assumes single module memory banks, given that you're running with 3 modules at present]
Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff