Fitting new head gasket set
Fitting new head gasket set
Author
Discussion

EdT

Original Poster:

5,239 posts

313 months

Wednesday 28th April 2010
quotequote all
Guys - the time (finally) approaches....
One question, does the head gasket set go on dry, or is something extra needed to help bond or anything?
(S1 2.8)

cheers all

Barkychoc

7,848 posts

233 months

Wednesday 28th April 2010
quotequote all
I haven't done many head gaskets but the ones I've done have always been dry.

ketvrin

3,504 posts

238 months

Wednesday 28th April 2010
quotequote all
Ed

Take a look at the Scorpio engine link in the useful links wiki
V6 engine section and you will see the whole job described very well
Torques, where to apply sealant etc etc

I'll know on friday if I need to do mine...

Fingers crossed I'll not

Good luck

K wink

EdT

Original Poster:

5,239 posts

313 months

Wednesday 28th April 2010
quotequote all
ketvrin said:
Ed

Take a look at the Scorpio engine link in the useful links wiki
V6 engine section and you will see the whole job described very well
Torques, where to apply sealant etc etc

I'll know on friday if I need to do mine...

Fingers crossed I'll not

Good luck

K wink
um sorry how do I get there?

Ragtop

592 posts

230 months

Thursday 29th April 2010
quotequote all

ketvrin

3,504 posts

238 months

Thursday 29th April 2010
quotequote all
Thats the one Graham... thumbup

sorry Ed I couldnt get the link from te useful links wiki to include in my message on my phone...

k wink

EdT

Original Poster:

5,239 posts

313 months

Thursday 29th April 2010
quotequote all
Ragtop said:
Looks like 2.9 EFI is the picture - not same as me (2.8i) does this matter do you think?

ketvrin

3,504 posts

238 months

Thursday 29th April 2010
quotequote all
Sorry again Ed I didnt notice you had a 2.8... but for your original question its the same ... i.e. dry
but ignore the torques and sequences on there in case they are different as I believe the 2.8 re-uses head bolts and does not use the Torx (stretch) bolts so they will be different.

sorry for any confusion I caused mate

K wink

kenpage

322 posts

235 months

Thursday 29th April 2010
quotequote all
hi have a look on a capri forum you should find all you need to know

Ragtop

592 posts

230 months

Thursday 29th April 2010
quotequote all
ketvrin said:
sorry for any confusion I caused mate

K wink
Ditto.

Graham

EdT

Original Poster:

5,239 posts

313 months

Tuesday 4th May 2010
quotequote all
The answer seems to be Hylomar Blue sealant. There was me thinking it was either green or red !!

M3CHA-MONK3Y

6,095 posts

224 months

Tuesday 4th May 2010
quotequote all
I used Hylomar Blue when fitting my head gasket, but I've got the 2.9.

EdT

Original Poster:

5,239 posts

313 months

Wednesday 5th May 2010
quotequote all
Well, progress... one head now fitted using Hyl. blue.. sure it'll be fine smile