racing harness
Discussion
It's an easy enough job. You need to replace come of the existing seatbelt mounting bolts with ring ended bolts (the harness then clips to the ring). Make sure that you get the longer bolts designed to go through GRP. The ones that come with the harness are for using in steel cars (steel is thinner than the GRP used by TVR, so you need long bolts to securely anchor the harness).
Replace the current setbelt bolts at both sides of the front seat, and the top mounting for the rear seatbelt (the one on the rear shelf). Then clip the 2 parts of the lap strap for the harness to the floor mounts, and clip the shoulder straps to the mounting point on the rear shelf. You'll need the type of harness where the shoulder straps join into one behind the seat, as there will only be one mount available for both straps.
James
Thanks for the info..much appreciated..if i struggle to do this myself would a dealer like "Mole Valley" be up to the job bearing in mind they run various race cars?.Hope to be sprinting at a new veneue in Essex,the Wethersfield Airfield Sprint which is a 4km course with nothing to hit if you loose it!!.
Gassing Station | Cerbera | Top of Page | What's New | My Stuff