Photoshop edit for the professionals out there!
Discussion
I was wondering if there were any pro users of Photoshop on here.
I've tried to edit the picture of my car on my profile but not had much luck, was wondering if someone could attempt it for me and send me the final result.
What i want to do is:
1) Get rid of the tyre marks on the ground, and if possible
2) Make it look like my headlights and fog lights were on although they werent, someone said this could be done but i havent got the foggiest.
IF any one can have a go that would be much appreciated
Cheers
I've tried to edit the picture of my car on my profile but not had much luck, was wondering if someone could attempt it for me and send me the final result.
What i want to do is:
1) Get rid of the tyre marks on the ground, and if possible
2) Make it look like my headlights and fog lights were on although they werent, someone said this could be done but i havent got the foggiest.
IF any one can have a go that would be much appreciated
Cheers
If you really care how...

- Cloned out the tyre marks with a low percentage and soft edged brush
- Made a Selection of the Lights, cutting around the indicators
- Feathered the Selection by 1pixel
- Filled with White on a New Layer and repeated until the brightness felt right
- Set the Layer to 'Hard Light' Overlay at a slightly lower Percentage
- Flattened it
- Applied the lens Flair Filter to the Layer with the Focus on one Light and again on one Foglight
- Job Done lol!

...try this for easy headlamps......
1 Make a new layer above the vehicle.
2 Fill this layer 100% black.
3 Change this layer to Colour Dodge.
4 With a white brush (slightly larger than the headlamps), draw a "dot" on the layer over the left light.
5 Go Edit>Fade and fade the brush mark to correct bloom opacity
6 repeat steps 4 & 5 using a smaller brush towards the centre of the headlamp.
7 When the desired effect is achieved for the left headlamp, duplicate this later.
8 Drag the duplicated layer to the right headlamp.
....see what you think - Easy!
1 Make a new layer above the vehicle.
2 Fill this layer 100% black.
3 Change this layer to Colour Dodge.
4 With a white brush (slightly larger than the headlamps), draw a "dot" on the layer over the left light.
5 Go Edit>Fade and fade the brush mark to correct bloom opacity
6 repeat steps 4 & 5 using a smaller brush towards the centre of the headlamp.
7 When the desired effect is achieved for the left headlamp, duplicate this later.
8 Drag the duplicated layer to the right headlamp.
....see what you think - Easy!
GFWilliams said:
you could have asked me to do it 
True didnt think about that, plus dont want to hassle you too mucsh as you've probably got a lot on with college, they look great though!
I may get you to do some with the wheels at some point as i want to get them re-sprayed but would like to see what they look like before i do them, think you took sime side shots of the car at gatwick.
Gassing Station | Photography & Video | Top of Page | What's New | My Stuff






you can tell I have an old car
