Steering Column Bearing and Housing

[Gerald-TVR]

Bought this off eBay



Sellers comments "This is a steering bulkhead bearing housing made in aluminium, not the usual plastic ones. It has stainless steel studs in so you do not need 10 ft long arms to fit it, just push through bulkhead and put nuts and washers on (also included and stainless steel). There is an aluminium disc to go in engine bay ( this needs finishing/ polishing )

There is a stainless steel bearing already fitted so this should be the last time you ever need to change this

I had one of these made for my car and it fitted perfectly and made the steering column feel a lot more solid

He has told me he could get some more made if there was some interest.

If anyone might be interested at the right price I will get some costings - let me know

[Barkychoc]

I'd be interested to know what sort of price they come out at Norman, though it would have to be down my list of priorities at the moment.

[Gerald-TVR]

I'll get some idea and let you know

Norman

[TonupS2]

Norman I would also be interested. Thanks Tony

[SteveOS3]

I'd be interested too if the price was not too high.

Steve

[grahamS2]

I would be interested, dependant on cost.

[T' Veteran Racer]

Norman
I would also be interested, if the cost was not to much more than the TVR Car Part item.

Pete

[Gerald-TVR]

Have asked waiting to hear about cost

[Road2Ruin]

Gerald-TVR said:

Have asked waiting to hear about cost

Nice to see I am not the only one in the office at some un-godly time in the morning. Still surfing PH though.

[Gerald-TVR]

Office is only 10 feet from my bed!!

[Barkychoc]

Gerald-TVR said:

Office is only 10 feet from my bed!!

I have the long commute downstairs

[Oldred_V8S]

Norman

I would be interested as well.

thanks

Paul

[Gerald-TVR]

Never had a reply as to cost will try again

[Oldred_V8S]

Gerald any luck with this? If you could let me have the contact details for the guy I will see if he would let me have the drawings if he is not keen to get them made himself.

Cheers
Paul.

[Gerald-TVR]

Paul

[e-mail] is his email address, if you get no joy let me know asap and I could lend you the bearing and housing as it not yet installed in the car, sometime in the next few weeks it will be

Norman

[Peter-S2]

Hi everyone, I'me the one that had the housing made, I'm trying to get some more made but my mate (who did the lathe work)is on sick leave at present, so as soon as he starts back he will try and make some more.I dont have drawings for it as I just told him what I wanted then drilled and tapped it myself. Let me know how many people want one so I can get enough made

[Gerald-TVR]

Thanks Peter - cummon Guys this is a good offer and idea

[mep12345]

Gerald-TVR said:

Thanks Peter - cummon Guys this is a good offer and idea

Count me in if price is reasonable - it would be a nice to do job not essential at the moment as the steering is fine

Mark

[geappleton]

Put me down for one aswell at the right price

[T' Veteran Racer]

I'm still interested, at the right price . Mine will need to be replaced for the next MOT in Feb.

Pete