Rear toe-in adjuster - washers?

[LuckyP]

Sorry for this numpty question.

Just putting the rear wishbones back on and I'm two washers per side spare!! Can someone with a better memory than me tell me how many washers are used on the wishbone end of the rear adjuster? If it's (from top) Bolt, washer, wishbone flange, washer, washer, rose joint, washer, washer, flange, washer, nyloc - then I'm OK. If its only 2 washers per side, then I have a washer glut and a wobbly adjuster!!

Can't find that bit in the build manual.

Ta.

Pete

Edited by LuckyP on Saturday 22 March 19:01

[GTRCLIVE]

Just space the joint to the middle of the plates....

[LuckyP]

GTRCLIVE said:

Just space the joint to the middle of the plates....

Cheers Clive, I stupidly took bolts out and collected the washers up off the floor at the end.......never again!!

I might pop over to Alan2 tomorrow to check his build.

Thanks mate.

Pete

[LuckyP]

Found it - "The toe link adjusters are fitted to the centre lug of the lower wishbone with the 2" bolts provided along with washers as spacers between the rose joints and the wishbone lugs."

Ta.

Pete