New Floor Fitting.....help
Discussion
HELP please......I'm having an issue with lining the floor up in my Mini van. It's a complete new floor from Minimachine, Tunnel, Cross member, Rear step, both floors, inner sills and outer sills. With the floor sitting on the tunnel at the front......like below
I jacked up the rear so it touches the load bed but it hits the load bed at the front just behind the door, but leaves the rear away from the load bed (see next shot).
Can anyone suggest where I'm going wrong or what I need to chop away or add metal too. The old floor at the front is still there a little and my thinking is I need to chop it back a little more to drop the front down more. Any thoughts will be very gratefully recieved as I don't wanna bugger this up or the floor (£550 worth!!!) .
Thanks in advance,
Mark
I jacked up the rear so it touches the load bed but it hits the load bed at the front just behind the door, but leaves the rear away from the load bed (see next shot).
Can anyone suggest where I'm going wrong or what I need to chop away or add metal too. The old floor at the front is still there a little and my thinking is I need to chop it back a little more to drop the front down more. Any thoughts will be very gratefully recieved as I don't wanna bugger this up or the floor (£550 worth!!!) .
Thanks in advance,
Mark
The link below takes you to my online folder....Hope you can help.
I think it's all down to panel manufacture and I need to adjust them to fit.
http://good-times.webshots.com/photo/2117428580094...
Thanks,
M
I think it's all down to panel manufacture and I need to adjust them to fit.
http://good-times.webshots.com/photo/2117428580094...
Thanks,
M
Gassing Station | Classic Minis | Top of Page | What's New | My Stuff