suspension bush lubrication?
suspension bush lubrication?
Author
Discussion

cortina1

Original Poster:

443 posts

248 months

Tuesday 29th August 2006
quotequote all
have not been out in the car for a while and went for a blast today, there was a right old sqeeking from the drivers rear area which I can only describe as a couple of canaries going at it.....would I be right in assuming the bushes are dry, I changed them out about 12months ago and thought I packed them sufficiently with grease, but maybe not enough? If its not these or anything obvious it could be I need to have a career break from my Pie Taster job......

lvjost

183 posts

241 months

Tuesday 29th August 2006
quotequote all
could be a hell lot of sources for the "birds"..to generate a sound like that, hearable when engine is turned on, you´d have to run metal bushes without grease ...think about parts like Doors, Hinges, Bolts not tightened, the pedals (mine do squeak), alloy panels where rivets losened a bit.....

cortina1

Original Poster:

443 posts

248 months

Thursday 31st August 2006
quotequote all
thanks Lutz....went though likely sources of the noise and found out one of the rear clip brackets had a fatigue crack which was half way through the bracket, factory advised me that the bracket can work harden and eventually crack, sent old front/back brackets back so they can use as a template to make some new ones. I have an older Spyder model so probably only relevent to Sport/Spyder owners to check.

cortina1

Original Poster:

443 posts

248 months

Thursday 31st August 2006
quotequote all
just to be clear its the alloy brackets that the pip pins locate in......

lvjost

183 posts

241 months

Friday 1st September 2006
quotequote all
nice to hear, you got the source...Didn´t really get, what you mean with "pin pip-bracket"...The rectangle taking the struts for the rear body, or the suspension of the body front/rear where the 12.7mm bolts go through and which are laminated into the GRP ? Got some pics...If it is what I´m thinking of, I might have a very proper solution for you...

yiihaa

338 posts

281 months

Friday 1st September 2006
quotequote all
lvjost said:
nice to hear, you got the source...Didn´t really get, what you mean with "pin pip-bracket"...The rectangle taking the struts for the rear body, or the suspension of the body front/rear where the 12.7mm bolts go through and which are laminated into the GRP ? Got some pics...If it is what I´m thinking of, I might have a very proper solution for you...


Different arrangement at the front of the rear clip on a Sport. (pre GTR)