3R Ball joints

[m12kop]

Any body know who's ball joint is used for lower rear?

[DanH]

Thought they were renault?

[m12_nathan]

Peugeot I think on a 3R depending on when they were switched by the factory, early cars were metro IIRC.

[DanH]

m12_nathan said:

Peugeot I think on a 3R depending on when they were switched by the factory, early cars were metro IIRC.

Yeah that was it. Knew it was a dodgey french company

[m12kop]

Thanks all.I'll pop down to my local dealer seen as i can't get through to noble

[m12_nathan]

605 rings a bell for some reason but best to get a dealer to take a look and see what they match up to.

[broad]

According to an old factory invoice of mine they are off a Citroen Xantia and have a part number of QSJ1184S.

With a quick 'google' that part number is a Quinton Hazell (aftermarket) part number and so you will get these from most motor factors. I think they are also as fitted to the Citroen C5/XM as well as Peugeots 405/406/605/607.

Hope that helps.

Graham

[m12kop]

Think i'm best ta king ball joint off and matching up at peugeot/citreon main agent rather than getting a factor part.

[broad]

You'd think so but that is what the Noble factory use themselves.

Also QH parts are often better made than the OE items (I replace loads of track rod ends with QH ones on rally cars for e.g.)

[m12kop]

Bought my QH ball joint from factor, 11 quid! thanks all.

[mr.man]

And before anyone rubbishes these ball joints the "original" one's wern't too clever in the first place!

[m12kop]

Just fitted the the joint but the insert in the hub was in 2 parts! Can you buy these?