Can’t find a clutch fitting?

[RedGTRUSA]

Hey Guys,

I’ve been searching for days and have had no luck. Anyone know a place I can find the correct size clutch line fitting that goes directly into the G50? My local auto parts stores don’t have anything that will fit. Size is always a little off. Thanks!

[davefiddes]

Yeah. That's a funny fitting on the Porsche clutch slave cylinder. I think it's an M12 taper fitting (which is virtually unheard of I think). What the factory do is use a parallel thread fitting (M12 I think - check with a bolt and/or thread guage) and a copper washer to seal against. It seems odd but works very well.

[builder]

RedGTRUSA said:

Hey Guys, I’ve been searching for days and have had no luck. Anyone know a place I can find the correct size clutch line fitting that goes directly into the G50? My local auto parts stores don’t have anything that will fit. Size is always a little off. Thanks!

Check with these guys...

-- Scott

[ultimichael]

Hi guys,

had a look at my Porsche clutch slave cylinder last night.
The thread is a M14 x 1,5, that means it´s a fine thread
with a thread pitch of 1,5 mm. Standard M14 bolts have a
thread pitch of 2 mm.
Hope this helps a bit.

Michael