Hall Effect Throttle position sensor
Hall Effect Throttle position sensor
Author
Discussion

Loubaruch

Original Poster:

1,393 posts

217 months

Friday 17th October
quotequote all
As the original carbon track TPS sensors are now obsolete and replacements are quite costly I decided to install an HE TPS, far superior and will outlast me!
https://www.bertram-hill.com/tvr-griffith.html

Sardonicus

19,249 posts

240 months

Friday 17th October
quotequote all
My original failed @ around 110k miles in the late 00's bloody hard to fault find before the now readily available diagnostic software mine was very specific to engine/plenum temp the engine would just fall flat on its arse and idle only and only under constant throttle for a period A roads and motorways , I managed to replicate the issue with a hot air gun aimed at the plenum whilst monitoring output voltages but was time consuming frown I purchased a new one from Land Rover when they was still available (about £60 IIRC) since the car is now on Megasquirt since 2010 data logging would of found the issue much sooner rolleyes this looks like a good solution to the wearing track issue which they all will succumb too eventually

phillpot

17,417 posts

202 months

Just fitted this kit to my V8s, straight forward enough thanks to Paul's clear instructions.
Only a short test drive so far but working perfectly. I made a little bracket to mount the terminal box that matches the coil bracket.


Edited by phillpot on Wednesday 5th November 14:43