Hanging Wallpaper
Discussion
The sequence I use is...
1. Measure length roughly
2. Cut roughly
3. Slap some Paste on
4. Put it on the wall
5. Butt it up
6. Slide to match pattern
7. Smooth out lumps and air bubbles
8. Trim top and bottom
However it's been suggested to me that I should measure exactly first time and cut the paper dry to avoid the possibility of tearing the "wet" paper (step 8)
What's your method ? :silly:
1. Measure length roughly
2. Cut roughly
3. Slap some Paste on
4. Put it on the wall
5. Butt it up
6. Slide to match pattern
7. Smooth out lumps and air bubbles
8. Trim top and bottom
However it's been suggested to me that I should measure exactly first time and cut the paper dry to avoid the possibility of tearing the "wet" paper (step 8)
What's your method ? :silly:
holbayhead said:
However it's been suggested to me that I should measure exactly first time and cut the paper dry to avoid the possibility of tearing the "wet" paper (step 8)
What's your method ?![]()
Who suggested this method? It's stupid. Impossible to do a decent job like that.
One thing I am good at is putting up wallpaper - I adopt the same standards as I do at work. I even trim top and bottom with a scalpel and 500mm straight edge

holbayhead said:
8. Trim top and bottom
However it's been suggested to me that I should measure exactly first time and cut the paper dry to avoid the possibility of tearing the "wet" paper (step 8)
What's your method ?![]()
As others have said a really sharp blade and a flat edge helps.
Alternatively if you're hanging a simple patterned wall lining dry cut the top to get it square and then you're only wet cut is at the bottom against the skirting.
ETA - I find applying paste to both the wall and the paper helps to slide the paper without it creasing.
Knowing this means I need to get out more
>> Edited by Sleep Envy on Tuesday 27th September 11:13
Gassing Station | The Pie & Piston Archive | Top of Page | What's New | My Stuff




I don't do enough to get good at it and I really can't be arsed trying.

