wots this squeek?
wots this squeek?
Author
Discussion

BERGS2

Original Poster:

2,828 posts

266 months

Sunday 22nd December 2024
quotequote all
Hi Guys - 

Quick question - I fired up the 997 this morning for the first time in a while - 

Had this  slighly odd sound: sort of a 'fluttery whistle' on idle

Can anyone help diagnose what it might be?

Car was serviced less than 100 miles ago - hadn't run for about two/three weeks

Ambient temp slighly cold here (4 degrees C), but nothing unusual?

Cheers y'all

​​​​​​​Bergs

M11rph

986 posts

39 months

Sunday 22nd December 2024
quotequote all
Might be as simple as one of those dried leaves being flicked by a fan?

Start with the easy stuff. Clear the leaves out.

[ Remembering that various fans can jump into life long after engine shutdown.Keep your fingers].

BAMoFo

947 posts

274 months

Sunday 22nd December 2024
quotequote all
My guess is that it is a bit of moisture on the rubber drive belt for the alternator and ancillaries. I had something similar in a 996 Turbo S.

ChrisW.

7,729 posts

273 months

Sunday 22nd December 2024
quotequote all
It has a revolving sound to me ... a dry pulley bearing ??

Maxym

2,508 posts

254 months

Sunday 22nd December 2024
quotequote all
Fan/leaf or similar. Nothing major, just irritating. Hopefully only temporarily.

(My amateur diagnosis, of course...)

Mr Squarekins

1,372 posts

80 months

Sunday 22nd December 2024
quotequote all
Bore score, probably cyl 3.

Just kidding wink my bet would be leaves in the heater vents.

Discombobulate

5,671 posts

204 months

Tuesday 24th December 2024
quotequote all
I hope it's a leaf but that sounds like a pulley to me...

FriedMarsBar

501 posts

50 months

Thursday 26th December 2024
quotequote all
On non Mezger engines you can take the airbox out and remove the aux bellt and then start the engine. If the source of the noise is a pulley or something connected to the aux belt, AC pump, alternator etc then the noise will be gone. If it is one of these you can turn each one individually to ID the issue.
https://www.youtube.com/watch?v=UtIr_ZNGMxE&t=...

Not sure if it's the same on a Mezger