pre-heat ICE car / oil before starting worthwhile?

[OctaneV8]

has anyone come up with a way to pre-heat an internal combustion engine car before starting the engine?



is it possible to significantly reduce engine wear by pre-heating the oil somehow by induction...

vs. cold-start followed by shortly driving off as gently as possible

[GeniusOfLove]

Electric block heaters are a thing in a lot of the world, Webasto fuel fired heaters that use petrol/diesel to pre heat the coolant (and cabin), and putting a little burner under the sump are all things.

None of which are worthwhile in the UK, when did you last hear of an engine actually wearing out in a passenger car?

[andy43]

You used to be able to buy a flat heater element sheet that would stick onto the sump and plug into mains power to preheat the oil. That’d be easier than a full Nordic preheater install but probably rubbish.

[AndySheff]

Only -4 here in Sweden, but I'm about to start my diesel cabin and engine heater. Soo nice getting into a toasty warm car

[alabbasi]

block heaters are common in colder climates for gasoline engine cars, and common everywhere for diesels. It's a factory open for many manufacturers. I even had one on an old 75 Mercedes Benz 300D (240D 3.0 in Europe).

[996TT02]

OctaneV8 said:

is it possible to significantly reduce engine wear by pre-heating the oil

What engine wear? This is not F1 where pistons are super super tight in bores and car can't be started before block is heated up to operating temperature, because clearances are designed for operating temperature.

Road cars - good clearances when cold, and technically too much when hot.

[stevieturbo]

OctaneV8 said:

has anyone come up with a way to pre-heat an internal combustion engine car before starting the engine?



is it possible to significantly reduce engine wear by pre-heating the oil somehow by induction...

vs. cold-start followed by shortly driving off as gently as possible

Plenty of ways available, but unless you live in the arctic, largely pointless.

[leef44]

andy43 said:

You used to be able to buy a flat heater element sheet that would stick onto the sump and plug into mains power to preheat the oil. That’d be easier than a full Nordic preheater install but probably rubbish.

This is what I had for my TVR. It would get it up to 60 degrees but normally I just heat it up to 40 degrees because it takes so long and is only heating a small portion of the oil. There is a general procedure of revving to a certain limit until the oil temperature reaches certain levels. This helped minimise that time and cold temp wear and tear.

Of course as soon as you turn it on and the engine is idling that temperature will start to drop as it circulates but I would say that it did help because it was a shorter time to get up to temp.

[Super Sonic]

Don't F1 cars run hot water through the engine before starting?

[PushedDover]

I click the button on the app to defrost the car and heat cabin and sorts it out.
If feeling precious, I also ‘start the car ‘ via the app too



Also great when leaving the airport / restaurant / cinema on an evening of course, not just on a morning.