450SE door/targa/hoop seals

[hillclimbmanic]

If it wasn't for my incessant questions, the Wedge Forum would be dead!

Which(If any!) is the best rubber seals supplier? Any recommendations?? I probably need all of them!

TIA

Manic

[phillpot]

They probably all come out of the same container from China so whoever is cheapest, Ebay?


https://www.ebay.co.uk/itm/224585233565

Edited by phillpot on Monday 4th November 17:17

[BlueWedgy]

Similar but at a slightly different angle.

https://www.woolies-trim.co.uk/c-38-top-seals

[keynsham]

I have used Seals Direct and Phoenix Trim. Both supply good quality mouldings and I have managed to get every TVR wedge and for that matter VW Camper van seal from one or the other!!

https://phoenixtrim.co.uk/

https://www.sealsdirect.co.uk/

[Wedg1e]

In the past I used to go to Paul Beck at Vintage Supplies:

https://vintageandclassicspares.co.uk/paul-beck-vi...

They used to sell some really rare old stock trim from the British car makers, certainly everything I ever needed for my wedges they had in stock.

[cirks]

keynsham said:

I have used Seals Direct and Phoenix Trim. Both supply good quality mouldings and I have managed to get every TVR wedge and for that matter VW Camper van seal from one or the other!!

https://phoenixtrim.co.uk/

https://www.sealsdirect.co.uk/

You don't happen to have the codes for the sealsdirect supplied ones do you (assuming 400SE or 450SE)?

[keynsham]

Not really. I have ordered a lot of seals from them for various vehicles in the last year or so and I only have email invoices which are not vehicle specific of course. When I ordered, I measured the geometry of the existing seal and looked on their website for a match. Most are directly replaceable. As I recall a few varied by a mm here and there but it made no difference to the fit (TVR tolerances!!)

[cirks]

keynsham said:

Not really. I have ordered a lot of seals from them for various vehicles in the last year or so and I only have email invoices which are not vehicle specific of course. When I ordered, I measured the geometry of the existing seal and looked on their website for a match. Most are directly replaceable. As I recall a few varied by a mm here and there but it made no difference to the fit (TVR tolerances!!)

okey dokey. Thanks