Air Bag light

Author
Discussion

Adrian-9iafn

Original Poster:

344 posts

87 months

Wednesday 21st August 2024
quotequote all
Hi all,

I recently replaced the door lock mechanism and in doing so removed the side door air bag and when refitting I put the battery back on to test some of the window mechanism before rewiring in the air bag. Ever since the dash light doesn't go off, so suspect it might be because at one point the battery was on and the airbag disconnected. Everything is as it was now and all working normally apart from the air bag light.

Any advice, ideas ?


eric1000

34 posts

227 months

Wednesday 21st August 2024
quotequote all
I reset my airbag warning light (amber) by disconnecting the battery for a few minutes.

Might be worth a go?

Adrian-9iafn

Original Poster:

344 posts

87 months

Thursday 22nd August 2024
quotequote all
Eric, hi

Thanks, I'll try again. I did try this, but worth another shot. I must remember to leave the bonnet unlocked this time !

Adrian-9iafn

Original Poster:

344 posts

87 months

Thursday 22nd August 2024
quotequote all
PS my airbag light is red

eric1000

34 posts

227 months

Thursday 22nd August 2024
quotequote all
Apologies, red won't be reset by disconnecting the battery. It probably needs connecting to a PIWIS.

Adrian-9iafn

Original Poster:

344 posts

87 months

Friday 23rd August 2024
quotequote all
I'll see if I can get it reset at the nest service then

eric1000

34 posts

227 months

Friday 23rd August 2024
quotequote all
For what it's worth, my amber light came on after I disconnected the under seat connector and switched the ignition on which "latched" the fault. Conveniently, a few days later I had a PCGB visit to Porsche Solihull, and one of the technicians offered to have a look at it, and quickly reset it (and told me about disconnecting the battery to reset amber warnings). It only took a couple of minutes, so dropping in to a customer friendly OPC/independent might be possible, if your service is a while off.

FriedMarsBar

470 posts

47 months

Friday 23rd August 2024
quotequote all
Maybe one of the mid price code readers like a Foxwell NT530 or ICarsoft Por 2 will do this.

I have a Foxwell and have used it a couple of times to reset lights on a couple of my cars and do a minor bit of coding on my 997.

Adrian-9iafn

Original Poster:

344 posts

87 months

Saturday 24th August 2024
quotequote all
Thanks

I've added a little piece of sticky backed black velour on top, the lights no longer visible so that will be good until I get a reset !