TVR Cerbera elbow rest

[Kitanimboy]

Hi all. I have a Cerbera 4.5, sounds awesome and goes like stink. Not long ago had front resprayed and just had a new windscreen fitted and it's looking pretty great for Salon Prive at Blenheim, but the padding in the elbow rest is looking a tad deflated and needs sorting, does anyone on here know the minimum amount of work I need to do to get that lozenge shaped panel off?

[Byker28i]

I think you have to take the helmet holder out, remove the gear knob, undo it at the front and then take the whole center console out as one. You can then work on it.

Maybe ask in the Cerbera forum

[Kitanimboy]

I'll try that, I just need to get to the back of it I'm assuming. Half expecting to find a couple of wing-nuts or something...

[notaping]

I seem to remember when I did mine that the passenger side was pop rivetted on. The driver side had nuts. Can't remember if they were wing or not. I don't know if this was because it had already been off or not. I drilled out the pop rivets and replaced with nuts and screws on passenger side. You should be able to get enough access by removing the helmet holder at the back then carefully lifting the centre section from the back. Don't force it or you might crack the fibreglass. You might need to remove the drivers seat to get better access.

[Sirbee]

https://www.cerbera.co.uk/armrest-dent-removal/

[Byker28i]

Spotted from my local scrapper
https://www.ebay.co.uk/itm/223030584756?itmmeta=01...

[Kitanimboy]

Thanks everybody... You were right. Helmet stow out, flex up tunnel cover carefully, felt under and found bolts. Job for the weekend.