Cerbera 4.5 - odd side inlet manifold wanted

[feithv8s]

Who can deliver me an odd side (passenger side) inlet manifold for my Cerb 4.5?
Flanges at heat barrior side are broken. I will see if it is possible to weld them, but I am afraid not.

Most surely caused by using 0,2 mm thicker heat barrior O-rings to overcome false air leak and resulting 2000 rpm idle when hot.

I installed these intakes and heat barriors two times earlier, but this evening it went wrong

BR, André.

[feithv8s]

To be clear, I mean the odd side throttle body housing

[porterpainter]

I guess ACT would be your best bet for a new one, or TVR Glen or Steve Strange (Douglas Valley) for a used one.

Hope you get it sorted.

[feithv8s]

Thx Porterpainter but I think you mean the air boxes which is not right.

I need the odd side throttle body with the 4 butterfly valves and injector connections. See enclosed earlier picture when it was not broken yet.

[Byker28i]

Thats going to be one of the scrappys I fear.

Check ebay for the usual sources that advertise on there. You may need to contact them.

[feithv8s]

Thanks.

More help is very welcome!!