Door Mirror 5 Connector

[Badgerchim]

Afternoon. Are the connector blocks or the pins still available. Unfortunately I have broken a male pin whilst depinning the connector so I could remove the mirror.



I don't want to fit a new connector if possible .

Thanks

[Adrian@]

Look up Lucas Rists TTS...an earlier version came with no tang...I think 3comp list them on eBay. A@

[Badgerchim]

Thank v much Adrian. I did look on eBay but missed them. Ordered.

[RayTVR]

How did you get the pins out? I’ve never had any joy trying to extract them.

[Steve_D]

RayTVR said:

How did you get the pins out? I’ve never had any joy trying to extract them.

Remove the plastic lock bar. Use a very fine screwdriver to push the latches in. To refit you first need to bend the latches out again.

Steve

[phillpot]

https://www.ebay.com/itm/184325921404?_trkparms=am...

[Badgerchim]

There's a bit of a knack to it but once you get the first done, the others seem easier. The first time I did it the same with small screwdrivers.
I have also used one of these but cut a slot in as the best fit one was not tight enough to compress the tangs.
As suggested on other posts make sure the wires are marked up so they go back in the same place