Intermittant misfire cylinder 6
Discussion
Hi all,
I have a 5.7 VXR that has an intermittant misfire on cylinder 6, this has been going on for ages now and has got worse.
Swapped coil and lead to another cylinder and also replaced all of the spark plugs but still shows cylinder 6.
My mechanic has tested all of the wiring and said that when it is cold there isn't a spark signal being sent to that coil but when warmed up it does so he thinks engine ECU issue?
Any suggestions regarding this?
Thanks in advance.
I have a 5.7 VXR that has an intermittant misfire on cylinder 6, this has been going on for ages now and has got worse.
Swapped coil and lead to another cylinder and also replaced all of the spark plugs but still shows cylinder 6.
My mechanic has tested all of the wiring and said that when it is cold there isn't a spark signal being sent to that coil but when warmed up it does so he thinks engine ECU issue?
Any suggestions regarding this?
Thanks in advance.
Well you have covered all of the basics.
The ecu is certainly a possibility especially when the coil pack isn’t getting a signal.
However a couple suggestions.
You didn’t mention having completed a full diagnostic check which would be my first port of call then, if all else fails carry out compression test on cylinder no 6 together with swapping around the injectors…( just in case)
Also check the colour and general condition of the spark plug which may indicate a lean mixture.
Keep us updated when you sort it out.
The ecu is certainly a possibility especially when the coil pack isn’t getting a signal.
However a couple suggestions.
You didn’t mention having completed a full diagnostic check which would be my first port of call then, if all else fails carry out compression test on cylinder no 6 together with swapping around the injectors…( just in case)
Also check the colour and general condition of the spark plug which may indicate a lean mixture.
Keep us updated when you sort it out.
Edited by mfp4073 on Monday 4th March 15:26
So the following parts a good, spark plug and lead, injector, ignition coil and wiring. A diagnostic was also carried out.
Now I’m struggling….as it’s only affecting one cylinder, have you considered a bore scope camera just to see if there is any damage in the cylinder/ piston or valve area. Maybe remove the valve cover and check the valve springs and rocker gear.
The best option is to swap over the ecu…..if anyone out there could loan you a good one for a quick test.
Sorry but i’m stuck….if I think of anything else I’ll post it.
John
Now I’m struggling….as it’s only affecting one cylinder, have you considered a bore scope camera just to see if there is any damage in the cylinder/ piston or valve area. Maybe remove the valve cover and check the valve springs and rocker gear.
The best option is to swap over the ecu…..if anyone out there could loan you a good one for a quick test.
Sorry but i’m stuck….if I think of anything else I’ll post it.
John
As you are from Cumbria you are not a million miles from AAS in Newcastle upon Tyne.
Give Stuart a call as he might have a few more suggestions, at least better than mine.
If you are still struggling he’s the man who will have a good chance of fixing it assuming you can get your car there.
The down side is he’s always very busy.
Give Stuart a call as he might have a few more suggestions, at least better than mine.
If you are still struggling he’s the man who will have a good chance of fixing it assuming you can get your car there.
The down side is he’s always very busy.
mfp4073 said:
As you are from Cumbria you are not a million miles from AAS in Newcastle upon Tyne.
Give Stuart a call as he might have a few more suggestions, at least better than mine.
If you are still struggling he’s the man who will have a good chance of fixing it assuming you can get your car there.
The down side is he’s always very busy.
Many thanks for your suggestion and advice Give Stuart a call as he might have a few more suggestions, at least better than mine.
If you are still struggling he’s the man who will have a good chance of fixing it assuming you can get your car there.
The down side is he’s always very busy.
I wouldn’t be sending your ecu away unless you are as sure as you can be they are genuine and recommend.
As far as I’m aware there was a guy on here called …speed for 4 you?, he had a few scrap Monaro’s he was breaking, I have bought some used parts from him in the past which were fine.
I’m not on face book but I believe there are some knowledgeable HSV owners on there that may be able to help
As far as I’m aware there was a guy on here called …speed for 4 you?, he had a few scrap Monaro’s he was breaking, I have bought some used parts from him in the past which were fine.
I’m not on face book but I believe there are some knowledgeable HSV owners on there that may be able to help
Assuming you trust the abilities of your chosen mechanic, it seems he has found the fault.
If no power is being sent to coil pack no.6 when cold then it is either the ecu or the wiring between the ecu and CP6.
Perfectly feasable for a component within the ecu to fail to do its thing when cold only to start working when the heat from the engine bay warms things up!
Could even be as simple as a dry joint.
As John above as posted, I'd be looking to make a trip to AAS and leave it with them.
Remember if you are looking at getting another 'used' ecu, the mapping of the 5.7 VXR is different to that of the CV8 and although I assume it would run just fine, you might loose 50 bhp or so!
If no power is being sent to coil pack no.6 when cold then it is either the ecu or the wiring between the ecu and CP6.
Perfectly feasable for a component within the ecu to fail to do its thing when cold only to start working when the heat from the engine bay warms things up!
Could even be as simple as a dry joint.
As John above as posted, I'd be looking to make a trip to AAS and leave it with them.
Remember if you are looking at getting another 'used' ecu, the mapping of the 5.7 VXR is different to that of the CV8 and although I assume it would run just fine, you might loose 50 bhp or so!
I assume you've seen this used one....
https://www.ebay.co.uk/itm/186206650987?itmmeta=01...
Available for £162 with code YUKPGI29Q4Y2G47M
CV8 ecu.
https://www.ebay.co.uk/itm/186206650987?itmmeta=01...
Available for £162 with code YUKPGI29Q4Y2G47M
CV8 ecu.
Lee20k said:
Hi all,
I have a 5.7 VXR that has an intermittant misfire on cylinder 6, this has been going on for ages now and has got worse.
Swapped coil and lead to another cylinder and also replaced all of the spark plugs but still shows cylinder 6.
My mechanic has tested all of the wiring and said that when it is cold there isn't a spark signal being sent to that coil but when warmed up it does so he thinks engine ECU issue?
Any suggestions regarding this?
Thanks in advance.
It is extremely unlikely an ecu fault.I have a 5.7 VXR that has an intermittant misfire on cylinder 6, this has been going on for ages now and has got worse.
Swapped coil and lead to another cylinder and also replaced all of the spark plugs but still shows cylinder 6.
My mechanic has tested all of the wiring and said that when it is cold there isn't a spark signal being sent to that coil but when warmed up it does so he thinks engine ECU issue?
Any suggestions regarding this?
Thanks in advance.
Exactly how has he been testing for the spark or trigger to the coil ? and is this misfire present at all times, or at least often enough to catch it testing ?
Is that injector firing ok ?
What is compression like on that cylinder vs others ?
Any odd noises etc ?
mfp4073 said:
I wouldn’t be sending your ecu away unless you are as sure as you can be they are genuine and recommend.
As far as I’m aware there was a guy on here called …speed for 4 you?, he had a few scrap Monaro’s he was breaking, I have bought some used parts from him in the past which were fine.
I’m not on face book but I believe there are some knowledgeable HSV owners on there that may be able to help
Yea I have bought quite a lot of stuff off of Brett in the past, will keep him in mind.As far as I’m aware there was a guy on here called …speed for 4 you?, he had a few scrap Monaro’s he was breaking, I have bought some used parts from him in the past which were fine.
I’m not on face book but I believe there are some knowledgeable HSV owners on there that may be able to help
Lincsls1 said:
Assuming you trust the abilities of your chosen mechanic, it seems he has found the fault.
If no power is being sent to coil pack no.6 when cold then it is either the ecu or the wiring between the ecu and CP6.
Perfectly feasable for a component within the ecu to fail to do its thing when cold only to start working when the heat from the engine bay warms things up!
Could even be as simple as a dry joint.
As John above as posted, I'd be looking to make a trip to AAS and leave it with them.
Remember if you are looking at getting another 'used' ecu, the mapping of the 5.7 VXR is different to that of the CV8 and although I assume it would run just fine, you might loose 50 bhp or so!
I trust my mechanic seeing as though he is my step son with his own garage lol.If no power is being sent to coil pack no.6 when cold then it is either the ecu or the wiring between the ecu and CP6.
Perfectly feasable for a component within the ecu to fail to do its thing when cold only to start working when the heat from the engine bay warms things up!
Could even be as simple as a dry joint.
As John above as posted, I'd be looking to make a trip to AAS and leave it with them.
Remember if you are looking at getting another 'used' ecu, the mapping of the 5.7 VXR is different to that of the CV8 and although I assume it would run just fine, you might loose 50 bhp or so!
Will keep AAS in mind.
Don't fancy losing any bhp thank you lol.
stevieturbo said:
It is extremely unlikely an ecu fault.
Exactly how has he been testing for the spark or trigger to the coil ? and is this misfire present at all times, or at least often enough to catch it testing ?
Is that injector firing ok ?
What is compression like on that cylinder vs others ?
Any odd noises etc ?
I think he has checked the voltage for the signals not 100% sure how he tested it but said the signal for a spark on coil 6 only sprang into life when it was warmed up, misfire is when cold then can suddenly spring back to life whilst driving.Exactly how has he been testing for the spark or trigger to the coil ? and is this misfire present at all times, or at least often enough to catch it testing ?
Is that injector firing ok ?
What is compression like on that cylinder vs others ?
Any odd noises etc ?
New injector.
Not done compression test yet and no odd noises.
Thank you all for your replies, much appreciated.
Lee20k said:
I think he has checked the voltage for the signals not 100% sure how he tested it but said the signal for a spark on coil 6 only sprang into life when it was warmed up, misfire is when cold then can suddenly spring back to life whilst driving.
New injector.
Not done compression test yet and no odd noises.
Thank you all for your replies, much appreciated.
Without knowing exactly what and how it was tested, cannot give any help as to whether the tests/results are valid.New injector.
Not done compression test yet and no odd noises.
Thank you all for your replies, much appreciated.
Why was the injector replaced ?
For an ecu signal to drop out and randomly appear, doesn't make sense.
Scope both the injector signal and coil trigger for that cylinder, or use a scope/current clamp and monitor all 8 coils to see if anything from the ecu is actually dropping out.
they're about the only tests that will give any real picture of what is, or is not happening
stevieturbo said:
Without knowing exactly what and how it was tested, cannot give any help as to whether the tests/results are valid.
Why was the injector replaced ?
For an ecu signal to drop out and randomly appear, doesn't make sense.
Scope both the injector signal and coil trigger for that cylinder, or use a scope/current clamp and monitor all 8 coils to see if anything from the ecu is actually dropping out.
they're about the only tests that will give any real picture of what is, or is not happening
Hi Stevie,Why was the injector replaced ?
For an ecu signal to drop out and randomly appear, doesn't make sense.
Scope both the injector signal and coil trigger for that cylinder, or use a scope/current clamp and monitor all 8 coils to see if anything from the ecu is actually dropping out.
they're about the only tests that will give any real picture of what is, or is not happening
I asked him to change the injector just to see if that was the issue.
Thanks for the advice I will pass this on to my step son to look into
.Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff