Help please - advice on cable routing

[Jimbo S2]

Hope someone can help, am installing an amplified sub-woofer, have feed the amp leads and power feed from the behind the shelf of the pax seat, into and up the tunnel past the gearshift up through the perforated cabin divider and was then hoping to feed them in behind the dash up just in front of the bulkhead. Have had a look under the dash (my it's tight under there!!) but cannot see any easy way of feeding the cables into the head unit. Am I missing something? Any tips please?

Jimbo :scratchchin:

[jig]

No, I couldn't find a way through either, so wrap the cables in some sort of sleeve for neatness (I used one of those spiral wraps) and then run them to the pax side under the dash where you can route it up the end of the shelf. If you take the left trim panel off you can feed the wire up into the dash to the head unit and power. Use a couple of cable ties to tie your new cable to the existing ones and it'll be as neat as a very tidy thing.

[Jimbo S2]

Jig,

Thanks mate followed your advice and it is now a tidy install. Can't wait to bolt the seats back in and go for a blast, roof off stereo turned right up.

Jimbo