Help identifying this E38 ABS wire clamp

[4004]

Having exhausted my knowledge of the ETK, turning to the PH gurus to see if anyone might know the p/n for these?
From what I can tell, they hold the ABS sensor wire in the wheel well (the part of it that goes from the harness to the sensor connection box).

I'd assume they would be in the 61 part group with the other electrical connectors, but can't see anything.

Edited by 4004 on Friday 10th March 21:40

[d_a_n1979]

On my iPhone. But they look like aftermarket P clamps to me

OEM ones were like a ladder type plastic clip IIRC

[4004]

That was one of my first thoughts, but I've seen a few early photos on what should've been original cars, and they were there.
I also couldn't find a close match in aftermarket catalogues.

Here is a slightly better picture - upper right corner

[d_a_n1979]

4004 said:

That was one of my first thoughts, but I've seen a few early photos on what should've been original cars, and they were there.
I also couldn't find a close match in aftermarket catalogues.

Here is a slightly better picture - upper right corner

They don't look familiar at all TBH

These are what I find on RealOEM: https://www.realoem.com/bmw/enUS/showparts?id=GJ83...

[4004]

For the sake of concluding this, the p/n for this is (61 13) 8 365 934, the part group being my assumption and confirmed by BMW.
They've also confirmed it has since been removed from ETK, so no dice ordering a new one. It was made by TRW.

Similar situation with door handle foams for the E38...