wipers and jet wshers
Discussion
I fitted these with Bosch Aerotwin wiper blades from Powers which work well:
http://www.racetechdirect.co.uk/rd70-tvr-car-part-...
http://www.racetechdirect.co.uk/rd70-tvr-car-part-...
cdmpw said:
I fitted these with Bosch Aerotwin wiper blades from Powers which work well:
http://www.racetechdirect.co.uk/rd70-tvr-car-part-...
I've got these as well on the Sag and they stop the water coming out when it shouldn't (unlike the standard tubes under acceleration). http://www.racetechdirect.co.uk/rd70-tvr-car-part-...
However, one dastardly day the water stopped coming out of one side when it should - transpired that the little plastic connector inside the rubber feed hose on that side had melted shut due to exhaust heat. Sawed off the melted end and replaced - all fine again.
I've got standard Bosch blades on there that were put on at service time but something more modern would be nice. I was warned about the curve of the screen though and some blades not able to cope / follow 'round the corner'.
Funny story actually - not long after the car was new I found that if the wipers were used at any geat road speed that the driver's side would push its arc slightly too far and catch around the A pillar pulling the wiper mechanism apart at the ball joint. I remember David Connolly doing some complicated mathematics before shortening one of the bars in the mechanism to stop this happening - perfect ever since. Thanks David, we miss you.
Gassing Station | Tamora, T350 & Sagaris | Top of Page | What's New | My Stuff