Usual boot question
Discussion
Cats said:
Thanks Nick
Just tried the boot again and it's working fine now - just weird!
Can it overheat - is there some kind of thermal cut out in the circuit?
Very strange
Maybe you should check the loom from the button to the solenoid. On mine the boot lid was removed some time in it's life and therefore they clipped the loom. Then someone did a botch job by just putting it together with tape. At some point there was a bad connection and the boot didn't open.Just tried the boot again and it's working fine now - just weird!
Can it overheat - is there some kind of thermal cut out in the circuit?
Very strange
EW486 said:
Cats said:
Thanks Nick
Just tried the boot again and it's working fine now - just weird!
Can it overheat - is there some kind of thermal cut out in the circuit?
Very strange
Maybe you should check the loom from the button to the solenoid. On mine the boot lid was removed some time in it's life and therefore they clipped the loom. Then someone did a botch job by just putting it together with tape. At some point there was a bad connection and the boot didn't open.Just tried the boot again and it's working fine now - just weird!
Can it overheat - is there some kind of thermal cut out in the circuit?
Very strange
Heavy'ish items can move/be thrown onto the button (flashing green(?) led) which disables all the opening solenoids. Believe it was an anti car-jack panic button?
Guess how I found this out? A couple of CD's were enough to press the button on my car!
Nick
my boot failed and it was just the button itself underneath the badge. when you open the boot using the secret method you can take the large round rubber caps out of the wall of the boot and get your hand in to undo the bolts holding on the badge. The just bridge the wires before the button and if the boot release works then its the button and not the wiring. Bought a new button for £10 and swapped it over with the old button and now its fine.
Gassing Station | Tuscan | Top of Page | What's New | My Stuff