Help socket size for Tusc S mk 11 hub please

[geoffphead]

hi guys anyone know what size the centre nut on hub is, my socket set only goes up to 32mm. Also is it to any torque settings?
any advice gratefully received
cheers Geoff

[Tuscanite]

The hub retaining nuts should be 230-250 ft lbs. I'll check the size on mine later if you haven't had any joy by then.
Check here if in doubt: http://www.varleyhyd.com/FJ062.asp

Good luck. Bob

[geoffphead]

Thanks Bob ive got the bible just didnt find hub removal and torque settings, that means a new wrench etc lol i would be grateful for size of socket though
cheers Geoff

[Tuscanite]

I've just checked and mine appear to be 19 mm. Are we talking about the same thing? These are the nuts holding the disc and hub assembly accessible with the wheels on and the centre decal removed? B

[geoffphead]

the big one in the centre, i think the three hub bolts become visible when centre nut is removed which are around 19

[VARLEYHYD]

geoffphead said:

the big one in the centre, i think the three hub bolts become visible when centre nut is removed which are around 19

41mm ( 1-5/8") on rear
right rh thread
left lh thread

Make a bar/ plate to hold the hub wheel studs from rotation

Hub capsscrews come from rear of hub

Upright has to come off to remove hub from upright

Leave/support drive shaft & CV and pull upright with hub from it

Hope this helps

GV

Edited - just checked & 41mm

Edited by VARLEYHYD on Saturday 14th September 21:11

[geoffphead]

cheers Graham so i undo 41mm nut and pull outwards , which bolts on upright need loosing off top or bottom? is there a pic in bible?
thanks in advance, i also polished everything in sight!!!

[VARLEYHYD]

geoffphead said:

cheers Graham so i undo 41mm nut and pull outwards , which bolts on upright need loosing off top or bottom? is there a pic in bible?
thanks in advance, i also polished everything in sight!!!

Remove nut
Tap/ knock output shaft to break away from the hub spline
Remove brake caliper
Remove all three upright bolts
Pull the upright away from the splined output shaft
Support drive shaft from strain
Remove hub from upright

Photos top right & below text at bottom of my web

Edited by VARLEYHYD on Sunday 15th September 09:07

[geoffphead]

Brilliant thanks Graham off to halfrauds to get larger socket
cheers