Stone chips in the paintwork
Discussion
You don't want to get involved in anything major if those are the only problems. Just a colour matched touch up pencil/brush on the affected chip, after a t-cut of the area, followed by a t-cut and polish, when completely hardened.
Care should be taken to just fill the chip with paint try not to spread it over the surrounding bodywork.
Care should be taken to just fill the chip with paint try not to spread it over the surrounding bodywork.
TVR-Stu said:
Sometimes its a good idea to use a pin or needle to just 'drop' small quantities of paint into a chip. Take care, as said in the post above not to add too much paint as you'll end up with a bump rather than dip.
Allow a few days at least before you consider final polishing.
Where is the best place to get the paint from? ThanksAllow a few days at least before you consider final polishing.
Gassing Station | S Series | Top of Page | What's New | My Stuff


