FttP - can you choose where it enters the building?

FttP - can you choose where it enters the building?

Author
Discussion

Blown2CV

Original Poster:

29,453 posts

209 months

Wednesday 21st December 2022
quotequote all
as per title!

Pachydermus

978 posts

118 months

Wednesday 21st December 2022
quotequote all
I had no issues when I asked to run mine into the loft and down to a utility cupboard. They did install a junction box at ground level though.

Bikerjon

2,211 posts

167 months

Wednesday 21st December 2022
quotequote all
From what I've seen, sometimes you can and sometimes you can't. Think it probably depends on the installer/how busy they are/if they are running late etc.

Ham_and_Jam

2,501 posts

103 months

Wednesday 21st December 2022
quotequote all
Blown2CV said:
as per title!
The installer we had was planning to feed it through the front of the house.

I asked for it to be fed down the side and directly into a utility cupboard in the kitchen diner.

He had a quick look, said it was a bit tight for him to access but would give it a go. He was a big lad! Anyway he managed it and did a very good and neat job.

Just ask the engineer who turns up, as long as it’s not unreasonable I’m sure most are accommodating.

moonigan

2,161 posts

247 months

Wednesday 21st December 2022
quotequote all
Mine was fitted where I wanted it but in my case the fibre was run from the nearest pole which happened to be in a neighbouring property and they were out so the engineer wouldn’t go in without their permission so I had to get in touch with them to gain access. The pole was at the rear of my property and I wanted it terminated at the front so the fibre runs from the pole to the side of my house and then down the wall to the front.


somouk

1,425 posts

204 months

Wednesday 21st December 2022
quotequote all
Generally speaking the install will account for a certain length of fibre, for my provider it was 50m as it was coming off a pole.

If you have an underground duct they may refuse to run the cable around the outside of the building due to how easy it is to damage and may require trunking it etc which adds cost. Will very much depend on what the installer wants to do and how much flexibility they have from the supplier.

Sheepshanks

34,470 posts

125 months

Wednesday 21st December 2022
quotequote all
Blown2CV said:
as per title!
Is it fed from overhead?

Ours is, and I asked for it to come in on the opposite side of the house to where the copper wiring is. No problem to do that.

I left them to it, only to find they'd drilled through the wall from the inside out (apparently they're told to do this) and had blown half the face of a brick off as the drill exited. Looks terrible. Annoyed with myself that I didn't drill the hole first - could have done it through a mortar joint and then filled it if it turned they couldn't use it.

somouk

1,425 posts

204 months

Wednesday 21st December 2022
quotequote all
Sheepshanks said:
I left them to it, only to find they'd drilled through the wall from the inside out (apparently they're told to do this) and had blown half the face of a brick off as the drill exited.
Mine was the same, luckily I had moved my car or the section of brick would have gone through the rear window. Blunt drill bits and too much of a rush to do the job didn't help.

768

14,842 posts

102 months

Wednesday 21st December 2022
quotequote all
Mine asked me where I wanted it routed, I asked what his suggestion would be, seemed sensible so we went with that.

SlidingSideways

1,345 posts

238 months

Wednesday 21st December 2022
quotequote all
They are pretty accommodating.
The cable is fibre (so glass essentially) right until it enters the house, so you do have to be somewhat sympathetic about run lengths and bend radii.