Discussion
i believe minispares do a lam bracket but i am not 100% sure as to if it is what you are after, if u wish to vue it yourself look at www.minispares.com hope it is ok
I always make my own brackets for my rally cars to take either Cibie Super-Oscars or the 8" PIAA spotlights. I can get 4 lights on the bracket if required, but normally only run 2 (with 100w bulbs it's all you really need).
If I knw how to post a photo on here I would do so, but I'll email a copy of a photo of one of my rally cars showing the lamps directly yo tou.
I use a 2.5" x 1/4" thick aluminium strip and 14 swg steel for the supports. The supports at each end are 2" wide and the centre one is 1" wide. At the top of each lamp I make up a steady from a long jubilee clip and screw this to the top of the front panel with rivnuts and small allen head cap screws.
The advantage with this type of bracket is that if I go off, not an unknown event, I find the brackets bend before damaging the bumper of front panel.
If I knw how to post a photo on here I would do so, but I'll email a copy of a photo of one of my rally cars showing the lamps directly yo tou.
I use a 2.5" x 1/4" thick aluminium strip and 14 swg steel for the supports. The supports at each end are 2" wide and the centre one is 1" wide. At the top of each lamp I make up a steady from a long jubilee clip and screw this to the top of the front panel with rivnuts and small allen head cap screws.
The advantage with this type of bracket is that if I go off, not an unknown event, I find the brackets bend before damaging the bumper of front panel.
Gassing Station | Classic Minis | Top of Page | What's New | My Stuff