Easy Ignition wiring question. Which wire goes where?
Discussion
I've just been gifted an Austin mini city that was about to be scrapped (far too good for that so I've taken it on as a project).
Somewhere in its life the ignition wiring has been pulled apart. I have the keys and want to re-wire her up but don't want to get it wrong and fry her and/or myself!
As you can see from the photo the brown, yellow and white wires are already connected leaving a thick red and white, a thick green and white and a thin green disconnected. There are 2 pins available one above the pin with the brown wire and one above the pin with yellow and white attached.
BeforeI go with trial and error and kill the whole electrical system (on board computer flux capacitor etc ;0) does anyone know what goes where? (Haynes manual is orders but won't get here till after the weekend!)
Somewhere in its life the ignition wiring has been pulled apart. I have the keys and want to re-wire her up but don't want to get it wrong and fry her and/or myself!
As you can see from the photo the brown, yellow and white wires are already connected leaving a thick red and white, a thick green and white and a thin green disconnected. There are 2 pins available one above the pin with the brown wire and one above the pin with yellow and white attached.
BeforeI go with trial and error and kill the whole electrical system (on board computer flux capacitor etc ;0) does anyone know what goes where? (Haynes manual is orders but won't get here till after the weekend!)
Gassing Station | Classic Minis | Top of Page | What's New | My Stuff