Griff hood leaks

Griff hood leaks

Author
Discussion

broscombe

Original Poster:

10 posts

266 months

Monday 9th December 2002
quotequote all
My griff hood leaks ,could anybody recommend a good water proofing agent to put on .

Prince_Charming

2,646 posts

276 months

Monday 9th December 2002
quotequote all
I don't even own a soft-top (yet!), but I believe the answer is Thompson's Water Seal from B&Q.

Check this out: www.pistonheads.com/gassing/topic.asp?t=22048&f=23&h=0&hw=thompson

Prince

rev-erend

21,536 posts

291 months

Monday 9th December 2002
quotequote all
I always use FABSEAL from a camping store.

Paint it on with a 3 inch brush.

I usually then spray any rubbers with silicone
spray (Halfords) once the FABSEAL is dry.

I did mine on Saturday and it cured my problems.

cutmonster

255 posts

277 months

Monday 9th December 2002
quotequote all
Or Renovo, who do a good range of hood products...
www.renovointernational.com

jodypress

1,940 posts

281 months

Monday 9th December 2002
quotequote all
sorry to say it but wasn't really impressed with rennovo stuff, after reading all recommendations etc. so got it fabsilled and its fine.

EdT

5,132 posts

291 months

Monday 9th December 2002
quotequote all
FABSILs the one - about £4 for big spraycan of the stuff.

Regards
Ed



>> Edited by EdT on Monday 9th December 17:15

davidd

6,529 posts

291 months

Monday 9th December 2002
quotequote all

EdT said: FABSILs the one - about £4 for big spraycan of the stuff.

Regards
Ed



>> Edited by EdT on Monday 9th December 17:15



Get Fabsil in a can, not the spray. It is much easier to put on. And remember the wetedge

D.

shpub

8,507 posts

279 months

Monday 9th December 2002
quotequote all

EdT said: FABSILs the one - about £4 for big spraycan of the stuff.



The last time I bought some Thomsons I got 2 x 5 litre cans for £14....

Steve
www.tvrbooks.co.uk

Blue Streak

28 posts

264 months

Tuesday 10th December 2002
quotequote all
Also may be worth taking the hood off cleaning the bodywork and then putting some silicon seal on the edge where the hood bolts on. This prevents water surging over the lip and then down the back. In my car it ran down just to the right of the seatbelts, now cured, but not before I needed a retrim...ow! (Previous owner let it leak) At the same time make sure your velcro is in the correct position and the rubber flaps are in place and that the silicon seal in the door lock gaps is in good condition.

simpo one

87,097 posts

272 months

Tuesday 10th December 2002
quotequote all
Bluestreak: Do you mean rubber seal or squoodgy silicone sealant from a tube?

broscombe

Original Poster:

10 posts

266 months

Tuesday 10th December 2002
quotequote all
Thanks guys, going to get some Fabseal now as this seems to be the one, cheers- Broscombe

griffman

390 posts

265 months

Saturday 14th December 2002
quotequote all
used fabsil spray can on all my past and present tivs,worth wearing a face mask though.