Wheel fitment for T ROC R (going to 18inch from 19inch)

[Dominicjeans]

Hi Folks!

I want to swap out my 19 inch wheels on my T Roc R 300 for smaller wheels. I believe that I can't go to 17inch wheels, but how can I check the fitment of 18inch wheels? I have found a set of 18inch wheels from a T Roc that look like they may fit (i.e. the holes are the same), but how can I be sure they will go on my R?

Thanks!

[Ryyy]

I know this is an oldish post but usually vw wheels have a 57.1 spigot/centre bore and a 5x112 pcd bolt pattern. The only other factors are offset and wheel width. This is a commonly used site and one I used for my caddy to see how my new alloys would sit versus stock steelies. https://www.willtheyfit.com/

If centre bore and pcd are the same the only factor is the other 2 I mentioned above which would possibly cause rubbing in the arches or actually fouling something mechanically. Idk if the site would say if it fouls a thing bit does say how much they would come out/in and you may know with that information if there would be a problem of you were to go to your vehicle and do some measuring. Hope this helps and you get sorted