Clubsport Reverse Motor.....how do I install?

[superlight7]

Anyone have pictures / diagram / instructions on how to fit this.

I've read the threads that its not the best system in the world but thought I would at least give it a go.

I've got the motor control box - I can see where it fits and connects but no clue as to how the ball bearing "clutch" thingy goes togethor and how it connects drive to the engine.

[radicaltechnical]

hopefully (if i have successfully uploaded it lol) the picture below shows the reverse motor with the clutch attached. the circlip shown is to hold the ball bearing in place and the piece i am holding, attached to the output shaft of the engine. hope this helps. [e-mail]

[superlight7]

Excellent - seems I'm only missing the ball bearings and the circlip - are these available as spares?

[lanan]

[jpivey]

I think there was a post ages ago R don't stock the circlip any more, ball bearing shouldn't be to hard to buy, are you racing the car as if not i'd leave it off...

[splitpin]

JPI's right; there's been quite a few on problematic 'it' I recall.

Here's one > http://www.pistonheads.com/gassing/topic.asp?h=0&a...

[ScottHughes]

Superlight have you managed to find a new circlip yet? just found out mine is missing?