bedding performance friction pads in
Discussion
They are supposed to be ready to race. That said...
http://www.performancefriction.com/pages/Race_tech...
I found you could pretty much get on them straight away. By the time tyres were up to full braking the pads were too.
http://www.performancefriction.com/pages/Race_tech...
I found you could pretty much get on them straight away. By the time tyres were up to full braking the pads were too.
i used to use them on race bikes, and was given the same advice when i got a set for the car..
make sure the disks are properly cleaned - as the pad material/mating needs to mate to the clean disk - not particles from other pads..
also advised to bed in and build heat slowly for first cycle - 10 laps or so, then let to cool before being ready to use in anger.
make sure the disks are properly cleaned - as the pad material/mating needs to mate to the clean disk - not particles from other pads..
also advised to bed in and build heat slowly for first cycle - 10 laps or so, then let to cool before being ready to use in anger.
Gassing Station | Radical | Top of Page | What's New | My Stuff