centre lock wheels adapter - 3/4" ??

[gixermark]

hi Guys,

are the std centre lock nut adapters for 3/4" drive ??

only just thought about this when packing up the truck tonight.. have borrowed a mates 3/4" T bar, will have to get a proper torque wrench to 200ft/ib at some stage i guess

is there such a thiing as a geared reduction drive from say 1/2" to 3/4 that not only changes the actual drive... but limits the actual torque required to reach the 200ft/lb if that makes sense ??

Mark.

[martvr]

Nope, they're half inch.

[gixermark]

ahh....

thanks for that.

is it hard with normal tools to get them up to the required torque ?? I just noticed my own torque wrench only goes to 150ft/lb and i am guessing my draper expert impact gun will be no use on these either ??

will take an extension with me - and check them after a few laps....

Mark.

[RobC]

Easy with a decent breaker bar, just jump on it for that last bit of torque

[Simon T]

Wait till the wheel cools down - a lot easier

Simon

www.tillingmotorsport.com