CS rear arb play?
Discussion
The rear arb on my CS (not niklinky) has about 1/2inch sideways movement. There must be some sidethrust in the setup as the witness marks are very clear. So there is 1/2inch clearance between the arb pivot blocks that the arb runs in and the locating washers welded to the arb.
First question...do they all do that (sir)?
Second question (if answer #1 is no) why is mine doing it?
The arb pivot blocks are narrower than the fixing plate which suggests maybe the blocks are too narrow.
The blocks and fixing plate can be seen here...
http://secure2.cyberware.co.uk/~rad-shop/acatalog/...
Thanks
Bert
First question...do they all do that (sir)?
Second question (if answer #1 is no) why is mine doing it?
The arb pivot blocks are narrower than the fixing plate which suggests maybe the blocks are too narrow.
The blocks and fixing plate can be seen here...
http://secure2.cyberware.co.uk/~rad-shop/acatalog/...
Thanks
Bert
Here is a picture of SportLibre's arb blocks
The blocks are both hard up to the welded on stops.
The blocks are those green pipe clamp type things (normally used for supporting hydraulic pipe).
The blocks are both hard up to the welded on stops.
The blocks are those green pipe clamp type things (normally used for supporting hydraulic pipe).
Edited by minitici on Wednesday 13th February 08:54
Edited by minitici on Wednesday 13th February 08:55
Gassing Station | Radical | Top of Page | What's New | My Stuff