Removing the crank pulley on a TF...

[cps13]

The head gasket has gone on my TF and I am looking at replacing it over the Xmas break, however I am not keen on lifting the engine out, I have a hoist etc but i'd rather leave it in place if I can.

Does anybody know if there is enough space to remove the crank shaft pulley without removing the engine?

Cheers,

[160steve]

The mechanic has just changed my hg without lifting the engine out so i assume there must be. I suspect it will be a fiddly job requiring lots of patience (it is an MG after all!)

[cps13]

Thanks Steve...