MG Badge

[68sebring]

Simple question, what size holes are needed for the skeleton MG badge and associated MG BGT lettering??

Thanks

Neil

[wildoliver]

3.0 mm from memory if your using the grommets, if using the metal clips use a 2.5 if you can.

[68sebring]

Glad I asked as I thought it was 4mm!!!

[wildoliver]

Well put it this way Midget side strips need a 3-3.2mm hole, the hole looks about the ideal size for the rear letters on a B/C although I haven't had to drill one for a while, the simple answer is measure the pips and drill that size hole!

Make sure you drill in the right place, measure again and again before drilling!