New Loom in BGT

[Aprisa]

Well I finally got my newly painted shell back from the sprayshop and am about to start putting everything back together.
Now as it's been such a long time since I dismantled it and started the renovation I have forgotten whether the back half of the loom is supposed to go underneath the car or inside?
This probably sounds really stupid but I can't find any help on the web or in the manuals!
Lookingto you guys.
Nick

[v8250]

Aprisa said:

Well I finally got my newly painted shell back from the sprayshop and am about to start putting everything back together.
Now as it's been such a long time since I dismantled it and started the renovation I have forgotten whether the back half of the loom is supposed to go underneath the car or inside?
This probably sounds really stupid but I can't find any help on the web or in the manuals!
Lookingto you guys. Nick

Nick, this normally runs underneath the car, however, try to run loom on the inside of the car to protect wiring. External wiring is too exposed underneath a car. Much nicer to have a clean dry wiring loom

[terenceb]

If you decide to take the good advice from above,fit the fuel pump in the boot area as well,far better than leaving it where it is.