Oil pressure sky high

Oil pressure sky high

Author
Discussion

Dave85chim

Original Poster:

467 posts

91 months

Tuesday 18th June
quotequote all
Hi all,

After a lengthy drive earlier - i noticed my oil presuure over the 90 psi gauge at idle- as soon as i pull off it goes down to 60 psi- hard acceleration down to 30 - then back to 90….

Any thoughts?

Dave85chim

Original Poster:

467 posts

91 months

Tuesday 18th June
quotequote all

s p a c e m a n

10,958 posts

153 months

Tuesday 18th June
quotequote all
That all sounds backwards to me, I'd be trying to verify the readings. Stick another sender in there and a cheap gauge, something like this .

https://www.ebay.co.uk/itm/266740231886?mkcid=16&a...

Check the sizes before buying because I just guessed

Steve_D

13,793 posts

263 months

Tuesday 18th June
quotequote all
Check and clean the connection at the sender it gets very dirty down there and plenty of vibration.
If memory serves (rare at my age) the gauge will go full scale if you disconnect the sender.

Steve

Dave85chim

Original Poster:

467 posts

91 months

Tuesday 18th June
quotequote all
Thanks Chaps - where is the sender located?

Sardonicus

19,073 posts

226 months

Tuesday 18th June
quotequote all
Under and behind crankshaft pulley, silver can shape in shot

PabloGee

427 posts

25 months

Wednesday 19th June
quotequote all
Yep, give the contact a clean.
Mine suffers from a bit of oil while my cork sump gasket gently weeps, and if I clean it up it performs better.
I don't get the high, mine drops to zero every so often, then comes back up.

Car drives nicely, so I'm confident it's just the sender signal getting fuzzy.

Dr Mike Oxgreen

4,201 posts

170 months

Wednesday 19th June
quotequote all
And it’s always worth remembering that the red light in the dashboard is driven by an entirely independent switch, nothing to do with the sender that drives the gauge.

If the gauge is showing strange readings but the red light hasn’t illuminated, it’s a 99% chance that the gauge sender is faulty or its connector is dirty and your oil pressure is fine.