Discussion
hi to all
does anyone know how to check the curb height without the vehicle height checking fixtures (special tools 6647 and 6648).
car is 1993 rt-10 ........ normal road running (not race track)
is this a critical setting ?...or does it just need to be equal both sides of the car.
i have all the other settings from shop manual :
camber
caster
toe
have there been any modifications to the shop manual settings for this model ?....or should they still be ok.
best regards
brian
does anyone know how to check the curb height without the vehicle height checking fixtures (special tools 6647 and 6648).
car is 1993 rt-10 ........ normal road running (not race track)
is this a critical setting ?...or does it just need to be equal both sides of the car.
i have all the other settings from shop manual :
camber
caster
toe
have there been any modifications to the shop manual settings for this model ?....or should they still be ok.
best regards
brian
you dont want be using 93 settings on your car, use the later 94 or 95 for a better ride
if you go to SH autos in bromsgrove they have a US laser/alignment measure with the viper settings all pre-programmed, its about £100 for a proper setup off them
if you go to SH autos in bromsgrove they have a US laser/alignment measure with the viper settings all pre-programmed, its about £100 for a proper setup off them
Edited by Viper on Wednesday 26th May 13:06
Gassing Station | Vipers | Top of Page | What's New | My Stuff