A few pics of 500 RAM's SRT-10 ram..........

[V1PER]

A few mods went on th truck this weekend.....
Look at that torque....






Good to see you both..
Baz Sam Shelby

Edited by V1PER on Sunday 3rd February 20:08

[Phoenix Viper]

Nice that well done Doctor Bob.

[fatboy18]

Sorry I kept interrupting you Baz

[Viper]

great numbers Andrew

[500 RAM]

Barry thank you for a great weekend, Andrew and Jenny

[vetteheadracer]

I like those headers! Any reason for choosing B&B over another make (I thought about a set of Gibson ones and also a flowmaster exhaust)? How easy were they to fit?

[V1PER]

Nigel
They are reasonably easy to fit..Just remove the inner wheel arch covers to make it easier..
The centre section was a bit of a pain though because it did not have flanges on the rear end where it met the backbox...So we had to cut the oldones off and weld them onto the new system...

Fitted the 02 simms but rather than cut the truck wiring I cut the clip of the old 02 and spliced them onto the clip and then pluged them into the truck wiring..and used the old 02 to bung the hole....


Sounds great though....
Baz