what connection wire do i need, help
Discussion
looks like SAE (as mentioned above)
https://www.sportsbikeshop.co.uk/motorcycle_parts/...
so depending on the trickle charger you get (some older ones were SAE which means it would just connect) but most likely the EL109 on the link will be needed.
https://www.sportsbikeshop.co.uk/motorcycle_parts/...
so depending on the trickle charger you get (some older ones were SAE which means it would just connect) but most likely the EL109 on the link will be needed.
That looks like a TM / KET connector – a legacy connector used in OptiMate battery chargers up to 2012. It depends what type of charger you are using as you will either need an adapter as shown in the above posted link or you could just buy a used Optimate III or earlier charger.
https://www.optimate.co.uk/connectors/
https://www.optimate.co.uk/connectors/
Some trickle charger connections use the same family of connectors as was used for disk drive power in older PCs.
You might be able to cut down a four way to fit.
They are often referred to as 'Molex' connectors, but Molex was just one manufacturer.
The pin spacing or 'pitch' is the main way of classifying usch connectors.
Most things are on ebay.
It
You might be able to cut down a four way to fit.
They are often referred to as 'Molex' connectors, but Molex was just one manufacturer.
The pin spacing or 'pitch' is the main way of classifying usch connectors.
Most things are on ebay.
It
oxford oximiser uses this connection, along with older optimate chargers:
https://www.ebay.co.uk/itm/325836328824?_skw=Oxfor...
I'd just get a ctek xs 0.8 though.
https://www.ebay.co.uk/itm/325836328824?_skw=Oxfor...
I'd just get a ctek xs 0.8 though.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff