Fixing waterproof seams

[JJ55]

My Oxford stormex cover has started to leak. It’s only around 15 months old & is in great condition bar the seam tape coming away in a couple of places leaving wet patches on my beloved bike! I’m assuming it’s caused by the heat of summer melting the tape.

What’s the best way to fix this? A quick scan on Amazon has opened my eyes to the world of seam repair. I’ve not found anything for bike covers though & not sure if some of the iron on tapes look strong enough for the job.

Has anyone here had the same issue & what did you use to fix it? I usually just attack these things with a roll of duct tape but I’m sure there’s a better solution.

Thanks in advance.

[Rubin215]

You get waterproof glue designed for this exact problem; I've used it on covers, tents, hillwalking kit etc.

A bit messy to use and very very sticky so better if you have a flat surface and someone to help you.

[bsidethecside]

I use Aquasure wetsuit adhesive for a lot of flexible, waterproof jobs, be it a wetsuit, wellies or a tent seam.

You can get a cure accelerator which is also thinners and can make application much easier - especially for seams and fabrics. It's slow curing, so will run if not level. Again the accelerator heops here. Repairs are very strong as long as the surface is clean.

Can be found in water sports shops / eBay / Amazon easily enough.

[JJ55]

Thanks for the responses, I will check out your suggestions

[TypeR]

I had some Oxford kit a few years ago that failed outside the warranty period. They replaced it foc, no questions asked.
You could try contacting them to see if you can get it replaced.

[KTMsm]

I haven't tried it but my go to solution is polyurethane

It's like silicone on steroids, have a google first

https://www.toolstation.com/bostik-pu91-polyuretha...