After a 2 stroke tuner
Discussion
As per the title, I'm going to do a top end rebuild of the Cagiva Mito in a bit and thought while it's in pieces, it'd be rude not to get someone to give the ports a tweak at the same time.
Mick Abbey was a name I'd been given but I can't get hold of him (I've left messages through facebook and on the phone) so I'm after recommendations if you know of anyone else.
Thanks in advance.
Mick Abbey was a name I'd been given but I can't get hold of him (I've left messages through facebook and on the phone) so I'm after recommendations if you know of anyone else.
Thanks in advance.
S2r said:
As per the title, I'm going to do a top end rebuild of the Cagiva Mito in a bit and thought while it's in pieces, it'd be rude not to get someone to give the ports a tweak at the same time.
Mick Abbey was a name I'd been given but I can't get hold of him (I've left messages through facebook and on the phone) so I'm after recommendations if you know of anyone else.
Thanks in advance.
Know the engine very well, there is not much to be had from doing any extra port work. Mick Abbey was a name I'd been given but I can't get hold of him (I've left messages through facebook and on the phone) so I'm after recommendations if you know of anyone else.
Thanks in advance.
Mick is very good, but as i said not much to be done.
Good pipe, set the squish to 1.00 make sure the jetting is ok and away you go.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff