Renewing prop shaft bearing on a monaro
Discussion
you need it jack it up high enough to have both wheels off the floor
Seperating both halves of the shaft may need a large hammer ,reinstall with plenty of coppa slip
you may need to remove the center section of exhaust to get the prop off
youll need a suitable diameter drift to knock it on the shaft. its a simple install with the correct tools
i marked everything up so it went back exactly how it came off.
Seperating both halves of the shaft may need a large hammer ,reinstall with plenty of coppa slip
you may need to remove the center section of exhaust to get the prop off
youll need a suitable diameter drift to knock it on the shaft. its a simple install with the correct tools
i marked everything up so it went back exactly how it came off.
Powermaster1 said:
Just wondering I’m going to attempt to change the prop shaft bearing on my monaro at home is there anything I should know as never done this before on any car
This is a good vid, there are probably more on Youtube.https://www.youtube.com/watch?v=HTRkpTCbbc4
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff