Monaro key programming
Discussion
I bought a genuine Holden key fob from Aus and after a month of travelling it arrived this morning. Was thinking of swapping the blade over from my old key but looking for advice on how to program it.
Seen the guidance for turning the ignition on and off umpteen times but people who’ve tried it say it doesn’t work. Is the only way to use Tech 2?
Seen the guidance for turning the ignition on and off umpteen times but people who’ve tried it say it doesn’t work. Is the only way to use Tech 2?
Hi wormus,
I did the same thing and bought a couple of new keys from Holmart for my 04 CV8. I took them to two places in the midlands that claimed to be able to program any key and both failed miserably.
I didn't fancy a drive to Rotherham so ended up getting them programmed at Walkinshaw's when I had the LS7 clutch fitted. I think you need a tech2 to do it.
All the best.
I did the same thing and bought a couple of new keys from Holmart for my 04 CV8. I took them to two places in the midlands that claimed to be able to program any key and both failed miserably.
I didn't fancy a drive to Rotherham so ended up getting them programmed at Walkinshaw's when I had the LS7 clutch fitted. I think you need a tech2 to do it.
All the best.
vxr2010 said:
what was wrong with your old key ? i bought a new fob and as the rubber buttons were perished i just swapped everything into the new fob , it is also easy to replace batteries using a soldering iron
Nothing. Just the battery is getting a bit iffy so bought a new fob from eBay. Don’t fancy destroying my old key to get the battery out.Mines a VZ so will try the manual method first. Fingers crossed.
wormus said:
Mines a VZ so will try the manual method first. Fingers crossed.
Not my original post but it does have the printout from factory manual https://www.pistonheads.com/gassing/topic.asp?h=0&...
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff