Discussion
Hi,
i have long tube headers fitted that connect to a walkinshaw exhaust system. I need to fit my sports cats that i have brought. Does anyone have any pictures of where they have located theirs?
Im stuggling to find a place to fit them as the pipe connected to the header has an s bend straight away to connect to the centre section that has a X pipe. If i fit them after the X pipe surely they will be far to far away from the engine and take ages (if ever) to get upto temp?
i have long tube headers fitted that connect to a walkinshaw exhaust system. I need to fit my sports cats that i have brought. Does anyone have any pictures of where they have located theirs?
Im stuggling to find a place to fit them as the pipe connected to the header has an s bend straight away to connect to the centre section that has a X pipe. If i fit them after the X pipe surely they will be far to far away from the engine and take ages (if ever) to get upto temp?
I've got Proflow longtubes with 3" magna flow cats fitted in the s bends connected to a wortec cat back, there wasn't a lot of room but the do fit.
There are some picks of them before I fitted them here:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
There are some picks of them before I fitted them here:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
L2VXR said:
I've got Proflow longtubes with 3" magna flow cats fitted in the s bends connected to a wortec cat back, there wasn't a lot of room but the do fit.
There are some picks of them before I fitted them here:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
I have the proflow LT and i have some magna flow cats. Will do the same as you, never though of cutting the cat down! Thanks There are some picks of them before I fitted them here:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
I think these measurements should get you started don't take them as a perfect fit as i still did a bit of fettling under the car and cut the bends slightly over size and slipped then through the flanges to get the length right. The two bolt flanges on the wortec are in the stock position and i did one side at a time so the cat back stayed bolted in the correct position . I think the 3.5" pipe i got from ebay and was 175mm CLR not 180mm as that was all i could find but it made little difference to the fitting
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff