tried everthing help metro 16v GTI

tried everthing help metro 16v GTI

Author
Discussion

sinky

Original Poster:

5 posts

253 months

Thursday 9th October 2003
quotequote all
Loss of power engine will idle all day but apply power and it stalls. so far checked coil, fuel pressure,vacume leaks,checked ecu fault code 20 (oxogen senser) tried to change this but even lucas could not find replacement any ideas???

annodomini2

6,913 posts

258 months

Friday 10th October 2003
quotequote all
Spi or mpi?

dizzy cap and rotor arm?

Compression test?

Jap-Car

640 posts

257 months

Friday 10th October 2003
quotequote all
Would a Rover dealer not be able to help you out with an oxygen (lamda) sensor?

jv_as

129 posts

262 months

Friday 10th October 2003
quotequote all
Fuel Pressure???

sinky

Original Poster:

5 posts

253 months

Saturday 11th October 2003
quotequote all
thanks guys fuel pressure ok compression test/dizzy/roter of the problem seems to be the oxygen sensor its a brass item with a push in connector but rover cannot find part and lucas says its not theirs ( its stampted lucas) anyone outthere with a K reg gti engine could you look at yoursl;

daxtojeiro

742 posts

253 months

Sunday 12th October 2003
quotequote all
Hi,
Im not convinced that a Lambda sensor would cause the fault you have. Most ECU's will only adjust the mixture by around 5% to correct for the AFR from the Lambda sensor. To prove it is the sensor you could find the wire from the sensor to the ECU, disconnect it from the sensor and put a 0.45V supply on it. This is the voltage for the stoichiometric point, that the ECU is trying to adjust the mixture to. If you still have the same problem then its not the fault. You can use a 1.5V battery and a potentiometer to get 0.45V.
Or you could read the voltage from your sensor, but they do tend to jump around a hell of a lot so it might not prove anything,
Phil