Winscreen washer all over the floor when pulling stalk…
Discussion
Hi folks,
Quick question if I may?
Yesterday I ran out of screen wash (I know, I know)
Filled up this morning and it took 5L
No water came onto the screen and after 20 mins or so the empty light returned
Filled up again at the office and there’s no leak until I pull the stalk and then it pees fluid onto the ground
So….it’s a leak.
Any idea if this is a common problem and one easily fixed at home with the wheel off?
Thank you
Quick question if I may?
Yesterday I ran out of screen wash (I know, I know)
Filled up this morning and it took 5L
No water came onto the screen and after 20 mins or so the empty light returned
Filled up again at the office and there’s no leak until I pull the stalk and then it pees fluid onto the ground
So….it’s a leak.
Any idea if this is a common problem and one easily fixed at home with the wheel off?
Thank you
boxsey said:
Yes it is. Remove the wheel arch liner. Push the pipe back on and secure it with a cable tie.
Brill. Is that an easy job of just taking the wheel off and pulling it out?From another forum (and using your reply) I've found the following:
At the top centre of the arch there will be IIRC 3 screws that join front to back. Work forwrad removing all teh other ones you see and also those that are on the trailing edge of the PU.
Easy job just a bit of fiddling to pull it out from the arch once all the screws are out
Seems easy enough!
C4SHONEY said:
I think same on mine due to the cold weather, not going to get hands dirty so off to opc. I feel a spanking comming my way.
Apart from that superb in the ice and snow.
My washers stopped working after the cold weather last year. Had the OPC check it when in for a service and they charged me about £2 to replace the T-piece in the pipe that was knackered.... Unfortunately they also charged me about 600 quid for the service!Apart from that superb in the ice and snow.
Gassing Station | Porsche General | Top of Page | What's New | My Stuff


