Crossflow & Roller Rockers
Discussion
Anyone have any experience of running roller rockers in a Crossflow?
If so I'm interested in whether it's a sensible way to raise cam lift without changing the cam. I've found a forum thread from Roger King saying it works well with old school low lift, long duration cams such as the A2.
Moto
If so I'm interested in whether it's a sensible way to raise cam lift without changing the cam. I've found a forum thread from Roger King saying it works well with old school low lift, long duration cams such as the A2.
Moto
Hi Moto
I have seen them with the same lift ratio, so no benefit that way. I assume you can get higher ratio. I am tempted to fit them on my rebuild, mainly as they seem quite reasonable and will cut side loads and wear.
Are your pistons pocketed for a higher lift? That may be your issue.
I have seen them with the same lift ratio, so no benefit that way. I assume you can get higher ratio. I am tempted to fit them on my rebuild, mainly as they seem quite reasonable and will cut side loads and wear.
Are your pistons pocketed for a higher lift? That may be your issue.
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff